Der Vortrag „Introduction to DFSS FMEA Normal Curve“ von Grey Campus ist Bestandteil des Kurses „Archiv - Six Sigma Green Belt - Full Package“. Der Vortrag ist dabei in folgende Kapitel unterteilt:
"Competitors are our Customers". Is this statement Correct ?
A characteristic of the normal curve is expressed as – “the area under the curve represents virtually 100% of the output the process is capable of producing”. Which characteristic does this describe?
A characteristic of the normal curve is expressed as – “the curve can be divided in half with equal pieces falling either side of the most frequently occurring value”. Which characteristic does this describe?
A characteristic of the normal curve is expressed as – “the curve theoretically never touches zero”. Which characteristic does this describe?
A characteristic of the normal curve is expressed as – “the peak of the process represents the center of the process”. Which characteristic does this describe?
For an Anderson-Darling normality test performed with certain data, the p-value is 0.029. What does this indicate?
The area under the normal curve can be expressed as
The total area under the normal curve between + 1 standard deviations and Target is:
The total area under the normal curve between +/- 2 standard deviations is:
The total area under the normal curve between +/- 3 standard deviations is:
For perfectly Normal data
Box Cox is advised as a last resort because
A random sample is selected from a population of measurements. The mean of the sample is not equal to the mean of the population. This is due to:
In a normally distributed curve which of the following statements are false?
In the graphical analysis if the kurtosis value comes out as zero what will be your interpretation?
For an Anderson-Darling normality test performed with certain data, the p-value is 0.45. What does this indicate?
In DMADV,V Stands for ?
A process FMEA is used to
In an FMEA, Occurrence is
In an FMEA, the Risk Priority Number is calculated by multiplying the severity, occurrence and detection numbers. RPN tells us
5 Sterne |
|
5 |
4 Sterne |
|
0 |
3 Sterne |
|
0 |
2 Sterne |
|
0 |
1 Stern |
|
0 |
... likely to occur, DET = How probable is detection of cause, RPN = Risk priority number in order to rank concerns; calculated as SEV x OCC x DET Process step Potential failure mode Potential failure effects SEV Potential causes OCC Current process controls DETRPN Actions recommended Responsibility (target date) Actions taken New SEV New OCC New DET New RPN What is the step? In what ways can the step go wrong? What is the impact on the customer if ...